...SELECT YOUR PRODUCT HERE
 



you are in HOME > LINEAR MOTION SYSTEMS > LINEAR MOTION BUSHES > LINEAR BUSH

Standard Type
   The outer circumference is a cylindrical shape with highest accuracy, and use is possible over a wide range of applications.

linear bushes are supplied in three series with different dimension systems.


Standard Type


Type LM : This is the metric dimension series used most frequently in Japan. Type LM...M : This is the stainless steel version of the type LM.
Type LME : This is the metric dimension series used most frequently in Europe.
Type LMB : This is the inch dimension series used mainly in the USA.


Open Type
   As the outer sleeve has been cut open for the part of one ball row (500 to 800), this type can be used when the shaft has been fixed to support shafts or support bases in order to prevent shaft flexion. Clearance adjustment also is possible easily.
LM...OP/LME...OP
LMB...OP/LM....MOP


Open Type


Seal Type
   This type has the same dimensions as the standard type, but special rubber seals are installed on one side or on both sides of the linear bushy to prevent entry of foreign matter and to prevent leakage of grease.
LM...UU/LME...UU/LM...MUU
(A single seal is indicated by ...U)
Seal types also exist for the clearance adjustment type and the open type


Seal Type


Clearance Adjustment Type
   This type has the same dimensions as the standard type, but as the outer sleeve is slotted in axial direction, it can be used for installation in a housing with adjustable inner diameter, so that the clearance with the shaft can be adjusted easily.
LM...AJ/LME...AJ
LMB...AJ/LM...MAJ


Clearance Adjustment Type


LM Case Unit Type SC
   This is a case unit with the standard linear bush installed in a small and light aluminum case. Installation is possible simply by bolting to a table.


LM Case Unit  Type SC


Shaft support type SK
   This is a lightweight support made of aluminum and used for shaft fixing. As the shaft installation part is slotted, the shaft can be clamped strongly by bolt tightening.


Shaft Support Type SK


Standard LM Shaft (Standard Stock) 
   High quality special shafts for the linear bush type LM is stocked in large numbers, and delivery is possible in short time. As shown in the photo, hollows shafts and shafts with end machining also are produced on request.


Standard LM Shaft (Standard Stock)




PRODUCTS || CONTACT US || HOME